Did you know that simple routine maintenance on your system can lower the cost of your energy bills significantly? If your furnace system is older than ten years, you could be saving up to 40% on your heating bills with a new energy efficient heating system.

In addition to reducing energy costs, regular maintenance helps prevent health and safety risk as cracks in a furnace system can cause serious health risk because of exposure to toxic fumes.

We have full-service capabilities throughout the life of your furnace, air conditioning, or boiler system. This includes installation, inspection, and ongoing maintenance to help prevent costly repairs. Our maintenance service includes:

•  Licensed Technicians

•  24-hour Service

•  Mobile Dispatching

•  3-hour Appointment Windows

•  Flat Rate Pricing

•  EPA Certified Procedures

•  Trane Certified

Furnace Inspection

Includes inspection of heat exchanger, air filter, burners, pilot, gas line, gas valve, safety controls, blower motor, blower wheels, capacitors, belts, combustion air opening, flue pipe, inductor motor assembly, flue draft, pressure switch, thermostat, fan switch, controls, relay and contacts, unit wiring, hot surface ignitor, flame restrictions, temperature rise, manifold gas pressure, condensation drain, and secure all panels.

Hot Water Boiler Clean & Safety Inspection

Includes inspection of boiler pressure, expansion tank, pressure relief valve, circulating pump, temperature set point, automatic draft vent damper, burners, pilot, gas line, gas valve, safety controls, combustion air opening, flue pipe, inductor motor assembly, flue draft, pressure switch, thermostat, controls, relay and contacts, unit wiring, hot surface ignitor, flame restrictions, manifold gas pressure, and secure all panels.

Air Conditioning Inspection & Cleaning

Includes inspection of thermostat, air filter, condenser coil, evaporator coil, blower assembly, refrigeration charge check, drain pan, condensate drain lines, condenser fan blade, condenser motor, test capacitors, wiring connections, measure volts and amps, disconnect box, compressor check, lubricant of motor and bearings, line set insulation, and secure all panels.