Did you know that simple routine maintenance on your system can lower the cost of your energy bills significantly? If your air conditioning system is older than ten years, you could be saving up to 40% on your cooling bills with a new energy efficient A/C system.

Whether you require a simple AC repair or full HVAC replacement, Kentwood HVAC is available 24/7. Our experienced technicians can service all makes and models and arrive with fully stocked vehicles for your convenience. You can always count on upfront written estimates and our 100% satisfaction guarantee.

We have full-service capabilities throughout the life of your air conditioning, furnace or boiler system. This includes installation, inspection, and ongoing maintenance to help prevent costly repairs. Our maintenance service includes:

•  Licensed Technicians

•  24-hour Service

•  Mobile Dispatching

•  3-hour Appointment Windows

•  Flat Rate Pricing

•  EPA Certified Procedures

•  Trane Certified

Air Conditioning Inspection & Cleaning

Includes inspection of thermostat, air filter, condenser coil, evaporator coil, blower assembly, refrigeration charge check, drain pan, condensate drain lines, condenser fan blade, condenser motor, test capacitors, wiring connections, measure volts and amps, disconnect box, compressor check, lubricant of motor and bearings, line set insulation, and secure all panels.

Furnace Inspection

Includes inspection of heat exchanger, air filter, burners, pilot, gas line, gas valve, safety controls, blower motor, blower wheels, capacitors, belts, combustion air opening, flue pipe, inductor motor assembly, flue draft, pressure switch, thermostat, fan switch, controls, relay and contacts, unit wiring, hot surface ignitor, flame restrictions, temperature rise, manifold gas pressure, condensation drain, and secure all panels.

Hot Water Boiler Clean & Safety Inspection

Includes inspection of boiler pressure, expansion tank, pressure relief valve, circulating pump, temperature set point, automatic draft vent damper, burners, pilot, gas line, gas valve, safety controls, combustion air opening, flue pipe, inductor motor assembly, flue draft, pressure switch, thermostat, controls, relay and contacts, unit wiring, hot surface ignitor, flame restrictions, manifold gas pressure, and secure all panels.